ABB ACH550 series, Installation Manual

Page: 20 / 42

Installation of the module
20
11. Connect the crossover network cable to the RJ-45 connector
of the router module with the network connector of your PC.
You can use a standard CAT 5 STP cable. Avoid parallel runs
with power cables, for example, motor cables.
12. Switch the drive power on again.
13. Wait till the steady orange STATUS LED of the router module
is no more on. It is lit for approximately 25 seconds in the
starting phase after power-up. During start-up, the router
module does not respond.
The flashing orange STATUS LED after start-up indicates that the
module is running with factory settings and needs to be
commissioned.
For more information on the LED indications of the router module,
see
LED indications on page 29.