ABB Ability, User Manual

Page: 50 / 100

8
A B B A B I L I T Y
T M
ED G E I N D US T R I A L G AT E WAY
50
—
8.1 How to install the product
The product is intended for professional use and must be installed by qualified personnel only.
The product must be installed in a secured location, accessible to authorized personnel only (for
example in a cabinet / technical compartment).
By default, the ABB Ability™ Edge Industrial Gateway comes with a DIN rail mounting clip fastened on
the bottom side. You can use this to install the ABB Ability™ Edge Industrial Gateway.
Optionally, you can replace the DIN Rail Mounting Clip with the Mounting bracket (optionally available).
See also:
• “How to Install the Product Using the Mounting Bracket” below.
• “How to Replace the Mounting Bracket with the DIN Rail Mounting Clip or Vice Versa” on the next page.
• “How to Install/Remove the Product on/from a DIN Rail” on page 53.
8.1.1 How to install the product using the mounting bracket
To install the product in place, complete the following steps:
1. See “Mechanical Specifications” on page 46.
2. Use the 4 slots available on the Mounting Bracket.
3. Add all the necessary mounting hardware to safely fasten the ABB Ability™ Edge Industrial Gateway
in place according to your installation requirements (for example use 4xM5 screws, with a minimum
length of 15mm).
Material, type, and length of the screws, and the maximum torque applicable,
depend on your installation requirements.
The Mounting Bracket is made of 2 mm aluminum alloy 6061 T6.
—
How to install the product
—
Figure 13