Assembly Instructions / A200-H
4 Installing the turbocharger / 4.3 Placing and aligning the turbochar-
ger on the bracket
© Copyright 2021 ABB. All rights reserved.
HZTL455311P0042_EN
Rev.A
September 2021
u
Make sure that the covers of the oil connections are removed.
u
Make sure that the position of the oil inlet of the bracket matches the oil inlet hole in the
bearing casing.
u
Make sure that the O-rings are placed correctly in the slots.
Step C - Placing the turbocharger
Fig. 9: Placing the turbocharger on the bracket
1. Lightly lubricate the hole in the bracket, into which the centering bush (04) is inserted,
with screw grease.
2. Position threaded rod with centering bush into bracket and insert until stop.
3. Carefully lower turbocharger onto bracket and position using the centering bush (04)
located in the bracket.
4. Check dimension X. If dimension X is not reached, the turbocharger must be lifted up
from the bracket and realigned.
The values X and L depend on the length of the threaded rod and must be specified by
the user.
5. Using the hexagon, screw the threaded rod into the bracket up to dimension L. If dimen-
sion L is not reached or the threaded rod jams while being screwed in, the threaded rod
must be loosened by no more than ½ revolution (this will loosen the centering bush
which may have jammed the rod). Then continue screwing in. If dimension L is not
reached, loosen the screw connection, carefully take the turbocharger off the bracket
and repeat the procedure starting with Step 1.
u
Comply with the steps for fastening the turbocharger:
¡
Fastening the turbocharger with a clamping nut
¡
Fastening the turbocharger with a standard nut
Page
13
/
21
Summary of Contents for A200-H
Page 2: ......