Abarth 2014 500, Owner'S Manual

Page: 168 / 211

REPLACING THE REAR
WINDOW WIPER BLADE
Proceed as follows:
❒
raise the cover A fig. 127 and remove
the arm from the car, undoing the nut
B fig. 127 that fastens it to the pivot
pin;
❒
correctly position the new arm and
tighten the nut fully;
❒
lower the cover.
JETS
Windscreen washer
If the jet of fluid is inadequate, firstly
check that there is fluid in the reservoir
(see "Checking levels" in this chapter).
Then check that the jet holes are not
clogged; use a needle to unblock them
if necessary.
The windscreen jets are directed by
adjusting the angle.
The jets should be directed at about
1/3 of the height from the top edge of
the windscreen fig. 128.
IMPORTANT In versions with a sun
roof, make sure that the sun roof is
closed before operating the front jets.
Rear window washer
The rear window washer jets are fixed.
The jet holder is on the rear window
fig. 129.
WARNING
137) Driving with worn windscreen/
rear window wiper blades is a
serious hazard, because visibility
is reduced in bad weather.
127
AB0A0113
128
AB0A0114
129
AB0A0115
164
SER
VICING
AND
MAINTENANCE