ABAC 2809913300, User Manual

Page: 26 / 180

5.1 You are advised to lubricate the tool before
each use (see section 6) (1).
5.2 Empty the magazine.
Connecting the air using the quick coupling (2).
5.3 Adjust the operating pressure so that it
remains within the operating pressure range
specified for the tool (3).
Load the fastening elements inside the
magazine according to the instructions in
paragraph 4.
5.4 Check that the fasteners penetrate correctly
by shooting nails into a wooden sample. If
the fasteners do not reach the desired depth,
adjust the air pressure to a higher value so as
to achieve the desired result. If the model is
equipped with a depth adjustment device, turn
the thumb wheel to obtain the desired depth
(4).
4.1 Connect the air tube (1).
4.2 Lower the magazine catch.
Pull the magazine cover back (2).
4.3 Insert a bar of fasteners into the magazine.
Make sure that the points of the fasteners are
loaded downwards. Also make sure that the
fasteners are not dirty or damaged (3).
4.4 Push the magazine cover forward until it
locks into place (4).
6.1 Disconnect the air supply from the tool
before lubricating it (1).
6.2 Add a few drops of tool oil to the air inlet.
Position the tool with the air inlet connector
facing upwards and place a drop of tool oil
inside the air inlet. Do not use cleaning oil or
additives. Put the tool into operation briefly
after adding the oil (2).
Wipe off any excess oil in the outlet. Excess oil
may damage the O-ring seals of the tool. If a
lubrication system is used, manual lubrication
through the air inlet will not be necessary on a
daily basis.
7.1 Fasteners jammed in the expulsion area:
Disconnect the tool from the air tube.
Manually lift the safety device, grip the jammed
fasteners with pliers and remove them (1).
Fasteners jammed inside the magazine:
Disconnect the tool from the air tube.
Pull the magazine cover back.
If necessary, manually lift the safety device and
remove any jammed fasteners.
Push the magazine cover forward until it locks
into place.
EN
6. LUBRICATION 4. LOADING THE TOOL
5. TOOL OPERATION
7. RELEASING THE JAMMED TOOL
WARNINGS: do not exceed a value of 8 bar
(0.8 Mpa)
1
1
2
2
3
3
4
4
OIL
8 bar
max
26 27