Optigo OP10 user manual
Chapter 6
Display and encoder
22
Chapter 6 Display and encoder
All setting and configuration is done using the display and encoder.
The menu information on the display is organised in a tree fashion. Using the encoder you
can move between menus, set values etc.
In any of the configuration menus, a click on the encoder will activate change mode. You
can then rotate the encoder button to move between choices or set values. A second click of
the button will accept the choice.
The menu system is divided into three levels: The Basic level, the 3-second level which
contains the clock and scheduler settings and the 10-second level which contains all the
configuration menus.
The Basic level
The Basic level comprises four sets of menu displays, the Base Display, the I/O Displays, the
alarm handling display and the Setpoint Display.
Base Display
This is an example of the Base Display, the display that is normally shown when there is no
operator activity.
This is an example of the Base display, the display that is normally shown when there is no
operator activity.
It shows the current time and the actual value of the main input parameter.
There are bar-graphs showing the current output levels together with symbols showing how
the outputs have been configured (Heating, Cooling or damper etc).
Also a symbol showing which of the five control modes is configured and an alarm symbol
that is displayed in the event of an alarm condition.
The fan symbol (control modes 1, 2 and 3 only) is lit as long as the fan indication input is
activated.
I/O
When the Base Display is shown, by twisting the knob counter clockwise until the text I/O is
displayed and then clicking on it, you can gain access to a menu where you can look at the
values and states of all inputs and outputs.
To exit this menu again, click on the knob and then twist the knob clockwise and you will be
returned to the Base display.