6.5.3
Insert the s-max into the lower bracket on the wheelchair
1.
Please use the locking brakes of your wheelchair to avoid any move-
ment of the chair while the s-max is being mounted.
2.
Pull in the s-max's climber entirely.
3.
Tilt the s-max slightly backwards and drive the device in the middle
of the wheelchair’s back.
4.
At this point push the s-max forward until the lower rod
is inser-
ted all the way into the lower bracket
on the wheelchair.
6.5.4
Insert the s-max into the upper bracket on the wheelchair
1.
Select the lowest climbing speed.
2.
Push the UP/DOWN switch, direction UP (never DOWN) so that the
climber moves in the direction of the attendant backward and
downward.
3.
As soon as the climber touches the ground the device is lifted. If the
s-max is positioned in the middle, the upper rod moves into the
claws of the upper bracket
. The rings are now at the inner sides of
the brackets.
F
Please note the information regarding the brackets with anti-tilt sup-
port in chapter 6.5.1
4.
As soon as the rod is all the way in the bracket, the wheelchair is lif-
ted. Release the UP/DOWN switch when the wheechair’s wheels are
approximately 1cm off the ground.
6.5.5
Fix the s-max to the wheelchair
1.
Take one of the quick pins
and with your thumb push down the lo-
cking bolt in the middle.
2.
Put the quick pin all the way into the drilled hole
of one of the up-
per brackets on the wheelchair and release the locking bolt.
3.
Now take the other locking pin and put it into the other bracket on
the wheelchair as described in point 2.
Only by using quick pins a strong connection between s-max and wheelchair
is secured.
22
S
-max
