Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
9
5. Programming controller in standalone mode
Controller KZ-1000-IP can be operated in stand-alone mode or network un-
der the supervisory software KaDe Premium Plus installed on your computer.
Working in stand-alone mode (without communication with the supervisor soft-
ware on the PC) must be programmed using the controller's built-in keypad.
There is no in this mode the possibility to monitor the system "on-line", integra-
tion with CCTV and generate reports. Cards added in this mode works without
any time limit. This mode is recommended for the control a few doors with a
small number of users.
It is also possible operation of the controller in the "off-line" after being pro-
grammed by supervisory software with controller connecting using TCP port.
Programming procedure using the keyboard controller
Signalling functions:
audible alarm (buzzer)
Single sound - the operation succeeded or enter the menu
Triple sound - the operation was not successful
Quad sound - at the selected position is already stored card
Five beeps - card with this number is already added
Optical indicator (LED)
Blue LED - Power on
Green LED - confirmation of the validity of the operation
Orange LED / flashing - waiting for the introduction of a code/password
Orange LED / steady light - the state of programming
5. 1 The procedure for entry into the programming mode
Press * - orange LED should blink
Enter the master code (default "000000")
Orange LED should light up permanently
If no password is entered correctly within 20 seconds after pressing * it auto-
matically returns to normal. Even after entering the programming mode, no key-
pad operation for 20 seconds to exit the programming mode. After entering the
programming mode, you can make only one type of operation. To perform the
next operation re-enter the programming mode.
Notes:
Default admin code
000000
must be change after first enter into pro-
gramming mode for own using
41
command code. Leave default code allows un-
authorized persons enter into programming mode and add own card. Reset ad-
min password is available from KaDe Premium Plus software - > Controller setup
-> Management password. New password should be download to the controller.
Procedure exited from programming mode
(After programming)
Press # - a single sound, orange LED goes out.
