Integrated Access Controller – Installation manual
All rights reserved. © AAT HOLDING S.A.
12
6.1 Adding a package of cards
After entering the programming mode enter the code
31
, then
Enter the ID of the first user of the package
Close the cards one of the other to the reader
After read each card reader will generate a single beep.
Repeat the operation for the next card
After loading press #
Read the card will be credited automatically generated ID numbers. The process
is best preceded by the preparation of a list of IDs, user names and card num-
bers.
6.2 Adding a single card
After entering the programming mode enter the code
32
, then
Enter the user ID from the list
Close the cards one of the other to the reader
After you read the card reader will generate a single beep and automatically exits
the programming mode.
6.3 Adding a package of cards with PIN codes (6 digits)
After entering the programming mode enter the code
33
, then
Enter the ID of the first user of the package
Close the cards one of the other to the reader
Enter the PIN -> enter the PIN again
Repeat the operation for subsequent reading cards with PIN codes
After each added card reader generate a single beep. Read the card will be cred-
ited automatically generated ID numbers.
After loading press #
6.4 Adding a single card with a PIN code
After entering the programming mode enter the code
34
, then
Enter the user ID from the list
Close the cards one of the other to the reader
Enter the PIN -> enter the PIN again
After you read the card and enter your PIN, the controller will generate a single
beep and automatically exits the programming mode.
6.5 Adding a group of users with PIN codes
After entering the programming mode enter the code
35
, then
Enter the ID of the first user of the package
Enter the PIN -> enter the PIN again
Repeat the operation to enter PIN codes for next users
After each added user controller will generate a single beep. PIN codes entered
will be added to the next automatically generated ID numbers.
after loading press #
6.6 Adding a single user with a PIN code
After entering the programming mode enter the code
36
, then
Enter the user ID from the list
Enter the PIN -> enter the PIN again
After a user added the controller generates a single beep and automatically exits
the programming mode.
