Frequently Asked Questions
General/Hardware
218
Position of LEDs on the OpenCom 150
With the OpenCom 150 Rack, the LEDs for LAN0 and LAN1 are placed on the front
panel.
19.1
General/Hardware
Question: The OpenCom 100 is not functioning.
Check whether the plug-in power supply is properly connected (OpenCom 130). If
an add-on module is installed: Make sure the mains plug is properly connected.
Plug another device into the mains socket to check whether there is any voltage.
Question: The mains plug is connected, the mains socket is supplying out-
put, but the OpenCom 100 still does not function.
DANGER!
This device contains hazardous voltages. To make the sys-
tem dead, remove the power plug and the plug-in power
supply from the socket.
Take the housing cover off. Is the “Power Fine” LED illuminated?
If not, contact your service centre or an authorised dealer. The AC adapter plug of
the OpenCom 100 may be defective.
Question: After restarting the OpenCom 100, nothing is indicated on the dis-
plays of any connected terminals.
It takes a short while for the OpenCom 100 to start up.
AC adapter
Power Good LED
Activity LED
LAN LEDs (Ethernet-Switch)
LAN LEDs
Summary of Contents for OpenCom 100
