1531-DBC 422 02 Uen B3 2013-12-02
8
I
NSTALLATION
7
Installation
7.1
How to start a new phone
To select the protocol, 7.6 Select H.323 protocol on page 21.
Connect one end of the network cable to the network outlet and the other
end to the connector marked LINE on the bottom of the IP phone. 6
Cabling on page 7.
If there is no LAN connection the text
No connection to the network
is
shown in the display.
This section is divided into one part if a DHCP server is used, 7.3.1
Starting a DBC 425 phone in a LAN with a DHCP server on page 14 and
into one part if fixed IP addresses are to be used 7.3.2 Manually setting
of the fixed IP addresses on page 18.
7.2
Starting a DBC 422 phone
7.2.1
Starting a phone in a LAN with a DHCP server
This section describes the procedure when the phone will use IP
addresses provided by a DHCP server.
After power up of the IP phone the LED at the mute key will be lit for a
couple of seconds. Then the display will show:
Figure 4:
The
x
indicates a timer counting down seconds.
If the system administrator wants to change the IP settings, the admin-
istrator mode must be entered before the timer x is counted down to
zero. If no procedure for the administrator mode is entered, or if the
Speaker
-key is pressed, the phone will use the current stored settings
and continue with the menu LAN access control.
If the procedure for administrator mode is entered, the following menu
appears:
