1531-DBC 422 02 Uen B3 2013-12-02
12
I
NSTALLATION
Figure 16:
The
x
indicates a timer counting down seconds.
To change the IP settings, enter the administrator mode before the timer
x is counted down to zero. If the administrator mode is not entered, or C
is pressed, the currently stored settings will be used and the
Getting
configuration file
menu is shown.
If the procedure for administrator mode is entered, the following menu
appears:
Figure 17:
If fixed IP addresses will be used, verify that the value for DHCP is
No
.
To change this value, press the
Speaker
key, the
+
key and then press
the
Speaker
key. The Network menu appears again. For a complete
survey of all menus in the Network settings, see 7.34.4 Change IP
settings in DBC 422 on page 70.
Enter the IP settings by using the +, - and Speaker keys for the entries
in the list.
Press the
C
key to exit from the settings menu and to continue the boot
procedure.
After this, the start up sequence is similar to the one when using DHCP,
see 7.2.1 Starting a phone in a LAN with a DHCP server on page 8.
7.2.3
Update of the software in the IP phone
This section is reached from 7.2.1 Starting a phone in a LAN with a
DHCP server on page 8 or from 7.2.2 Manually setting of the fixed IP
addresses on page 11.
Two types of updates may be performed on the IP phone:
•
Update of both the application software and the bootROM.
•
Update of only the application software.
