INSTALLATION INSTRUCTION
11 (50)
Prepared (also subject responsible if other)
No.
Mario PRANZL
6/1537-ASB 150 02 Uen
Approved
Checked
Date
Rev
Reference
Ulf SÖDERMARK
2012-02-16
H
3.6
Set IP Settings
Setup the network parameters according to customer’s network requirements.
Go to Configuration (Basic) / Network Settings / IP Settings and enter:
Parameter
Value
IP Address
x.x.x.x
Subnet Mask
x.x.x.x
Default Gateway Address
x.x.x.x
NAT IP Address
0.0.0.0
NAT IP Address: Is required, if you run ISDN SIG GW behind a NAT router and a public
static IP address is used. In this case set the public IP address. For dynamic public IP
address use an STUN server.
Click Submit to save the changes.
At this point the ISDN SIP GW does not respond anymore to the old IP address (10.1.10.10).
Change your PCs IP address accordingly to be able to connect to the new address.
Note: Don’t power off or reset the ISDN SIP GW before the next step is successfully done!
Reconnect and Logon.
Click Burn to store the new IP address permanently in flash memory.
