Configure the network settings
ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07
1-11
Aastra CNX Installation and Setup Procedures
Configure the network settings
Requirements
The following is required before you configure the Aastra CNX for the first time:
•
The Aastra CNX must physically be connected to your console using an
RS-232/DB-9 cable.
•
The Aastra CNX must physically be connected to your network interface via
the Ethernet port(s).
•
The Aastra CNX must be turned on.
•
You must be running a terminal emulator on your PC. Terminal emulator must
be set as follows:
— Baud Rate
9600
— Data
8 bit
— Parity
None
— Stop
1 bit
— Flow Control
None
After powering up the Aastra CNX, a network script runs in a terminal emulator
window allowing you to initially configure the unit for your network.
Procedure
The following procedure describes how to configure the network settings.
Note:
If at any time during the initial configuration process, you want to
backout of the configuration, press
<ESC>
to cancel.
7
