Line Keys and Programmable Keys
41-001523-00 REV00 – 04.2014
91
Using the Paging Key
The following procedure describes the use of the
Paging
key on the IP phone. The procedure assumes you have already
configured the
Paging
key using the Aastra Web UI.
Expansion Module Keys
7.
Select from Key
1
through Key
16
.
8.
In the
Type
field, select
Paging
.
9.
In the
Value
field, enter a multicast IP address and a port number for the Paging key. When you press this key, the
phone initiates an outgoing multicast RTP session to the specified address using the specified port. (For example,
239.0.1.15:10000).
Notes:
1. When you select
Paging
for the
Type
field, the
Line
field is disabled.
2. The
Value
field allows for one multicast address entry only.
10.
To receive RTP steams for Group Paging, you must also configure the
Paging Listen Addresses
parameter at the
path,
Basic Settings > Preferences > Group Paging RTP Settings
. For more information about setting this parameter, see
.
11.
Click
Save Settings
to save your changes
Notes:
•
The recipient of a Paging call can set a global Do Not Disturb (DND) to ignore any incoming pages.
•
For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is dependant on the
Allow Barge In parameter setting and the Idling/On Call state.
IP Phone UI
1.
On the IP phone, press the key you configured for Paging.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays.
2.
Press the
Drop
key to end the multicast RTP session and return to the idle screen.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.
