15
mode see the Unit Reset instructions on pages 10 & 11.
NOTE: You can also toggle the sleep code with the telephone. (See intercom operating
instructions.)
To program or change your sleep code enter the following;
(MASTER CODE) + 4 + 1 + SLEEP CODE
Should you make a code entry error, simply press the
*
key and enter the correct code. You
may select any 4 digit sleep code you wish. If you receive an ERROR, you must select
another code as it is already in use. The unit will respond with a GOOD BEEP with the
acceptance of the new Sleep Code and you will be exited from the program mode.
(Set Latch Code)
EXPLANATION: The Latch Code toggles the state of the main relay (A) of the circuit board.
The red LED will light if the relay is in the latched position. The latch code is useful in
applications where the gate is desired to hold open. If the operator's close circuit is
controlled by loops, timers, etc., they will be overridden by the latched state of the relay and
the gate will hold open. An "OPEN-OVERRIDE" circuit must exist in the operator in order to
utilize this function. If your gate cycles when this code is entered, your operator is not set up
to utilize this function. Your local dealer or distributor should be able to assist you if you
have any specific questions.
To program or change your latch code enter the following;
(MASTER CODE) + 4 + 2 + LATCH CODE
Should you make a code entry error, simply press the * key and enter the correct code. You
may select any 4 digit latch code you wish. If you receive an ERROR, you must select another
code as it is already in use. The unit will respond with a GOOD BEEP with the acceptance of
the new Latch Code and you will be exited from the program mode. When the latch code is
entered the RED Led will light and the gate will hold open. When the latch code is entered
again the RED Led will go off and the gate will close. NOTE: On gates with a timer to close
the “TIMED DURATION” starts when the latch code is released.
Call Forwarding:
Call Forwarding is located under Sub Mode 4 with Sleep and Latch modes as follows:
Sub Mode 4 (Call Forwarding)
To program or change the phone number dialed, enter:
(MASTER CODE) + 4 + 3 (*status) + 2 + (Phone Number – 7, 10, or 11 digits)
To disable call forwarding:
(MASTER CODE) + 4 + 3 (*status) + 0
To enable call forwarding:
(MASTER CODE) + 4 + 3 (*status) + 1
*status:
Single beep = enabled
