13
Press and release HWRESET button.
The idle mode
The idle mode is the normal mode of operation. When in this mode the unit sits and waits for
data from the keypad. When in this mode you will have approximately 4 seconds between key
presses. If this time is exceeded, you will receive an ERROR.
The program mode
The program mode is the mode of operation in which you will enter, delete, or change your
codes or set specific features of the unit. The program mode is accessed by entering the
"MASTER CODE" from the keypad. You will receive a GOOD BEEP and the yellow LED will
come on indicating that you are in the program mode. In this mode you will have
approximately 30 seconds between key presses. If this time is exceeded, you will receive an
ERROR and be exited from the program mode.
The
*
and
#
keys
The
*
and
#
keys serve specific functions while in the idle or program mode. The
*
key is
always the clear key and a double beep will be heard when depressed. You should use this
key if you make an entry error. The # key also serves as the clear key in the idle mode. In the
program mode however, it serves as the exit key and will at any time when depressed, exit
you from the program mode.
PROGRAMMING
A person desiring access to the program mode will enter the present MASTER CODE. If the
master code is valid the yellow LED will come on and the individual will be prompted with a
GOOD BEEP to enter a number corresponding to a SUB-MODE.
Remember: Master Code will not activate control relay.
(MASTER CODE) + (Number corresponding to Sub-Mode).
Once in the program mode, the individual will have 30 seconds between key presses or the
unit will ERROR and exit the program mode. A person desiring to exit the program mode may
do so by simply pressing the # key at any time. There are 10 different SUB-MODES to choose
from. They are as follows:
SUB-MODE DESCRIPTION
1
Program Access Codes (Relay A)
2 Delete
Codes
3
Change
Master
Code
4
Set Sleep Code , Latch Code and/or Call Forwarding
5
Set
One
Shot
Code
6
Set Relay Output Times
7
Program Access Codes (Relay B)
8
Enable / Disable "3 Strikes-You’re Out"
9
Program
Event
Input
0 Erase
Memory
