A&D GF-1000, Instruction Manual

Page: 13 / 82

11
4. DISPLAY SYMBOLS AND KEY OPERATION
Key operation
Key operation affects how the balance functions. The basic key operations are:
“Press and release the key immediately” or “Press the key”
= normal key operation during measurement
“Press and hold the key”
Display symbols
Each key, when pressed or when pressed and held, functions as follows:
Key When pressed When pressed and held
Turns the display ON or OFF. The standby indicator is displayed when the display is
turned off. The weighing mode is enabled when the display is turned on.
This key is available anytime. Pressing the key during operation will interrupt the
operation and turn the display OFF.
In the weighing mode, turns the minimum
weighing value ON or OFF.
In the counting or percent mode, enters
the sample storing mode.
Enters the function table mode. Refer to
“10. FUNCTION TABLE”.
Switches the weighing units stored in the
function table. Refer to “5. WEIGHING
UNITS”. Enters the response adjustment/self check
mode.
No function. Enters the calibration mode.
Stores the weighing data in memory or
outputs to a printer or personal computer
using the RS-232C interface (Factory
setting), depending on the function table
settings. No function at the factory setting
By changing the function table:
Outputs “Title block” and “End block” for
GLP report.
Displays the data memory menu.
Sets the display to zero.
Stabilization indicator
Processing indicator
Response indicators
Comparator
indicators
Standby indicator
Animal mode indicator
・
Displays data stored in memory
・ Displays the weighing data relative to the
weighing capacity, in percentage, in the
weighing mode
Weighing data
or stored data
Units
Interval memory
standby indicator
Blinking indicators
Interval memory
active indicator
Data number of the
data currently displayed
Processing indicator
(Capacity indicator)
(Displayed for about 30 seconds
when weighing starts.)