Operators and Maintenance Manual
Display
EEM AM4 FE H01
Page
10/19
Copyright:
Auto & Aero Technologies Sp. z o.o.
Mazowiecka 10/5, 20-723 Lublin, Poland
■
email: [email protected]
■
www.aatech.pl
The EEM AM4 display displays values of flight and engine parameters that
are either directly measured or calculated by the system. The display starts
automatically as the power is turned on.
As shown in Figure 6, the monitors with 01 AR02 software version
presents:
1.
Display A (upper left):
a.
Engine speed
–
in the left side of the display;
b.
Rotor speed
–
in the right side of the display;
2.
Display B (upper right):
a.
Inlet air pressure
–
in the upper left quarter of the
display;
b.
Inlet air temperature
–
in the bottom left quarter of the
display;
c.
Oil pressure
–
in the upper right quarter of the display;
d.
Oil temperature
–
in the bottom right quarter of the
display;
3.
Display C (bottom left):
a.
Cylinder head temperature
–
in the middle of the display;
its right bar graph shows the temperature of the right
side of the cylinder head, and the left bar graph
–
the
temperature on the left of cylinder head;
b.
Exhaust gas temperature
–
in the bottom of the display;
its right bar graph shows the temperature measured of
the right side of the engine, and the left bar graph
–
the
temperature on the left.
4.
Display D (bottom right):
a.
Hobbs (total engine running time) - digits in the bottom
right of the display;
b.
Voltage
–
the upper left of the display;
c.
Number of recorded threshold crossings
–
the upper
centre of the display (e00);
d.
Flight time (measured from the last start of the engine)
–
digits in the bottom left of the display;
