COMMAND
NAME
DESCRIPTION
N
o
.
COMMAND SYNT
AX
Command
Argument 1
Argument 2
Argument 3
Argument 4
Response
Totalizers
Sets and controls action of
the fl
ow T
otalizers.
NOTE:
Start totalizer at Flow value has to
be entered in %FS (0.0 – 100.0)
Limit volume has to be entered in
currently selected mass EU
If T
otalizer hit limit event is not
required, set “Limit V
olume”
value (argument 4) to zero.
Totalize
U
s support Count
Up mode only.
If Auto Reset mode is Enabled the
Totalizer volume will be reset to
zero as soon as T
otalizer reading
reaches “Limit V
olume” value.
Totalizers reading are stored in
EEPROM (non volatile) memor
y.
Power
cycle will not affect T
otalizers reading.
In addition T
otalizers reading are
backed up in separate EEPROM
partition with 6 minutes inter
val. In
case of error T
otalizers reading may
be restored from backup location.
Totalizers cannot be reset if Reset
Lock parameter value set to 1.
15
T
1
(T
otalizer #1)
2 (T
otalizer #2)
Z
(Reset to zero)
T1Z or T2Z
C –
Start fl
ow and Event
Condition
<value> (start totalizer
at fl
ow)
%FS [0.0 – 100.0]
<value> (Limit
volume in current
volume based EU)
T1C:2.5, 0.0 (limit not required)
or
T2C:2.0,20580.5
P – Power On Delay
<value> (0-3600 sec.)
T1P:10 or T2P:20
D
(disable totalizer)*
T1:D or T2:D
E
(enable totalizer)
T1:E or T2:E
R
(read current totalizer
volume reading)
T1R:<value> or
T2R:<value>
(in current EU)
S
(read current
settings status)
T1S:Mode,StartFlow
,LimitV
olume,
PowOnDelay
, AutoResetMode,
AutoResetDelay
Example: T1S:E,0.5, 2045.2,10,0,5
A
Set Auto Reset mode
<value> [0-1]
0 – Disable 1 – Enable
T1A:0 - disabled
Or T2A:1 - enabled
I
Set Auto Reset Inter
val delay
<value>
[0-3600 sec.]
T1I:2 Or T2I:0
B
Restore T
otalizer
value from EE backup
T1B or T2B
L
Totalizer Lock status
read / set
No Argument
(read Lock status)
T1L:0 or T2L:0
<value> [0-1]
Set Lock mode
0 - Unlock 1 - Lock
T1L:1 or T2L:1
