2-19
Chapter 2: Motherboard information
9.
USB 3.0 connector (20-1 pin USB3_56)
This connector is for the additional USB 3.0 ports. Connect the USB 3.0
bracket cable to this connector, then install the USB 3.0 bracket to the
rear side of the chassis. If your chassis support customized front panel
installation, with USB 3.0 header, you can have a front panel USB 3.0
solution.
NOTE:
The USB module cable is purchased separately.
IMPORTANT!
• Before you install Windows® 7, go to the Advanced tab of the BIOS Setup
program and configure the following items: XHCI mode [Disabled] and USB
(EHCI support) [Enabled]. You can re-configure these BIOS items after the
Windows
®
7 installation.
• You can download the Intel-released XHCI Driver Creator Utility for
Windows 7 from:
https://downloadcenter.intel.com/download/25476/
Windows-7-USB-3-0-Creator-Utility
Installing Windows
®
7 in Skylake platform
1. Use the Windows
®
7 XHCI Driver Creator Utility to pack the XHCI driver into
the original Windows
®
7 OS image. A new Windows
®
7 OS image will be
created.
2. Use the new OS image to install Windows
®
7.
EM
B-
Q
170C
EMB-Q170C
USB3.0 Front panel connectors
USB3_56
+5V USB3_RXDN5 USB3_RXDP5 GND USB3_TXDN5 USB3_TXDP5 GND USB2_PN4 USB2_PP4 GND
PIN 1
+5V
USB3_RXDN6 USB3_RXDP6
GND
USB3_TXDN6 USB3_TXDP6
GND
USB2_PN5 USB2_PP5
