AADCO 737 Series, Operating Instructions Manual

Page: 7 / 72

3
1.9
For INSTALLATION WITH COMPRESSOR, place the compressor assembly,
Figures 1 and 2 (50), between two level surfaces so that the underside of the
assembly is exposed.
DO NOT INVERT . Remove the two red shipping bolts
located on the underside and retain for future use.
1.10 Place the generator unit and compressor unit side by side as shown in Figures 1
and 2, with the compressor unit, Figures 1 and 2 (50), left of the generator unit as
shown. Place the ballast tank Figures 1 and 9 (16), on top of the compressor
unit and install the curved metal tubing which is supplied and labeled, Figure 2
(53), between the compressor outlet fitting and the check valve on the ballast
tank, Figures 1, 2 and 9 (24).
1.11 Install the ¼-inch o.d. plastic tubing, Figure 1 (51), supplied between the outlet
fitting on top of the ballast tank and the PUMP fitting, Figure 1 (58), on the rear of
the generator unit. Lastly, install the dump muffler in the DUMP fitting Figure 1
(60) and direct downward.
1.12 Connect the compressor power cord into the AUX POWER outlet on the lower
rear of the generator unit, as shown in Figure 1. Once the six-foot power cord
has been inserted into the proper electrical outlet, the unit is ready for operation.