7
Installation Instructions
Ozone Generator Placement
• Install the SP Series in a clean, dry area with good ventilation.
• Select a location for the ozone generator that is as close as possible to the ozone
injection point.
• The SP Series enclosure is not rain proof, so it is important to choose a location that will
keep the system away from direct weather and excessive heat.
• The ozone generator should be placed above water level because if pressure is lost in
the venturi vacuum, gravity will cause water to travel down the ozone output tube and
enter into the ozonator.
• Situate the unit in a manner suitable for convenient electrical access.
• Mounting holes are located on the back of the ozone generator for convenient wall
mounting (mounting hardware is not provided).
• The basic installation method for the SP Series system is through a venturi injector
manifold plumbing connection.
• The venturi Injector manifold must be assembled (venturi injector is sold separately).
NOTE:
Be sure to place the ozone generator in temperatures 40 and 100 degrees
Fahrenheit (4.5 to 38 degrees Celsius).
Venturi Injector Installation
A typical venturi injector manifold
• Refer to the Venturi Injector Installation diagram and follow the instructions below if the
ozone is being injected directly into the full flow of the pool’s return line: