6220M Mainboard Chapter 3 Award BIOS Setup
19
If you select
‘Auto’,
the
BIOS will detect the HDD & CD-ROM Drive automatically
at the POST stage and show the IDE for HDD & CD-ROM Drive. If you select
‘user’
,
you will need to know the information listed below. This information should be from
your hard disk vender or dealer. Then enter the figure directly and press <Enter>. If
the controller of the HDD interface is ESDI, the selection shall be ‘
Type 1’
; if SCSI,
the selection shall be
‘None’
. If no device is installed select
‘NONE’
and press
<Enter>.
Type
drive type
SIZE
automatically adjusts
CYLS
number of cylinders
HEAD
number of heads
PRECOMP write precom
LANDZ
landing zone
SECTOR
number of sectors
MODE
mode type
Drive A, Drive B
This category identifies the types of floppy disk drive A or drive B
that has been installed in the computer.
None
No floppy drive installed
360K, 5.25 in 5.25“ PC-type 360KB capacity
1.2M, 5.25 in 5.25“ AT-type 1.2MB capacity
720K, 3.5 in
3.5“ double-side 720KB capacity
1.44M, 3.5 in 3.5“ double-side 1.44MB capacity
2.88M, 3.5 in 3.5“ double-side 2.88MB capacity
Floppy 3 Mode Support
This is the Japanese standard floppy drive. This standard
stores 1.2MB in a 3.5” diskette.
Video
This category selects the type of video adapter used for the primary system
monitor. Although secondary monitors are supported, you do not have to select the
type in Setup.
EGA/VGA Enhanced Graphics Adapter/Video Graphics Array. For EGA, VGA,
SEGA, SVGA or PGA monitor adapters
CGA 40
Color Graphics Adapters, power up in 40 column mode
CGA 80
Color Graphics Adapters, power up in 80 column mode
MONO
Monochrome adapter, includes high resolution monochrome adapters
