A.O. Smith LILY, User Manual

Page: 14 / 56

ENG 12
• Installation of inlet tube:
Take out the 1/4” tube from the accessory box, and cut to suitable
length with scissors, connect one end of the inlet tube to the inlet end of
the 3-way joint (See Diagram 4), then screw the nut tightly. The other
end of inlet tube connect to the “Source” of the unit connector.
Note to fix the tube and quick connector to avoid water leakage issues.
• Installation of the electronic faucet:
Drill a φ 20-35 mm hole in an appropriate position on the counter where
the faucet is to be installed. Then take out the faucet from the water
purifier accessory bag. Begin the installation of the faucet. In the
counter where the faucet is to be installed, drill a 20-35mm hole in an
appropriate position, then take out the faucet from the water purifier
accessory bag, start the faucet installation (See Diagram 7):
A) Basement Installation: install the rubber cushion into the metal cushion,
take out 2 pieces M4mm screw, and fix the screw on the metal cushion
through the basement hole, then pull the connectors of faucet through
the basement Pull the faucet cable through the plastic basement, rubber
cushion and the metal cushion in series, and combine the rubber cushion
and metal cushion together, then take out the M4mm screws and fix one
screw to metal cushion started from plastic basement. Then put the plastic
basement through the sink hole and insert the cushions, then install
another screw and fix tight 2 screws.
NOTE: don’t fix the screw to tight once, it should be fixed in steps, and
don’t use strong force.
B) Main Part Installation:
Cut a suitable length 1/4” tube and insert one end into the bottom quick
snap of main part, and connect another end to the “Source” connector
of the unit, then press down the main part on the basement.
C) Gooseneck Installation
Make sure all 3 O rings are in the O ring slot of gooseneck tube, then dip
some water on the end with O rings, then insert into the output nozzle of
main part.
• Installation of the Second Faucet Outlet Converter
Lily water treatment system can be connected to outlet connection with
the converter that comes as standard feature inside the package. With
this converter, it possible to connect the system to your refrigerator or to a
second faucet.
Water System Connection:
Connect the pure water pipe to the converter IN end then connect the
OUT end to the one end of three-way connector, after that connect other
two ends of the three-way connector to the E-faucet and M-faucet.
Electrical System Connection:
Connect the one wire connector on the converter to the E-faucet and the
other one connect to the wire from the units. These wire are apple to
apple connection.
Diagram 7