Read Before Use
Before installation and use of this device, please read this manual carefully and keep it ready for future
reference.
Engage an experienced water heater installer. A. O. Smith and AOS Bath will not be held liable by any
damages or piping leakages caused by incorrect installations.
This heater is suitable for residential use. Any attempts to use it for commercial purposes will reduce the
heater lifespan. Once the heater has been installed, owners should run checks every 6 months and the
system should undergo maintenance every 3 years. If there are any operational irregularities, please
discontinue use of the heater immediately and call our company hotline.
Before any instances of heater repair and maintenance, users should disconnect the power supply. Any
modifications and repairs should only be handled by company approved technicians.
Heaters may cause serious scalding. Mix hot with cold water before showering or taking a bath.
If heater suffers from dry heating, any resultant steam and hot water may cause serious scalding. As a
result, users should ensure that the heater tank is always full of water. If dry heating occurs, immediately
cut off electrical & water supply and stop using the heater. Call our company service hotline and wait for
our approved technicians to do the necessary checks and repair.
For safety issues, do not change any of the settings of the pressure relief valve or temperature pressure
relief valve. Ensure all blockages are clear and install a drainage pipe to allow the overflow water to be
discharged into a floor drain.
Water produced by the heater is not potable and should not be consumed.
Any circuits, gauges, circuit breakers and wiring used for the heater must meet current ampere
requirements and be checked by approved technicians. Do not use damaged circuitry or an outdated,
loose, unstable power outlet for the heater. This will cause electrical shocks, fuses, fires, etc.
Heater electrical connections must be used in tandem with a dedicated power source located at a dry
area. Do not handle electrical points with wet hands. This may cause electrocution or physical damage to
self.
A white translucent colour to the water produced by the heater is considered normal. This is due to the air
pockets or foam caused by the pressure of dissolved air in water after heating.
Note
: Incomplete compliance of this manual’s contents may cause fires, financial or property losses,
personal harm or death.
Warning
: This is an electronic appliance and must be used with reliable connections.
4
