Join an existing Powerline AV Network
：
Step 1. Press and hold the Pair button on Powerline adaptor C for more than 10 seconds until both the
Powerline and Power LED are off, then release the button and the Power LED will start blinking.
Step 2. Press the Pair button of Powerline adaptor B for 2 seconds.
Step 3. Press the Pair button on Powerline adaptor C for 2 seconds
(This must be done within 120 seconds after pressing the Pair button of Powerline adaptor B.)
Step 4. Wait for about 60 seconds while your Powerline adaptors are connecting. The Power LED on
Powerline adaptor B and C will stop blinking and light up when the connection is made.
Step 5. Now Powerline adaptor A, B and C are connected.
Pair Button Behavior
The following table summarizes the actions that occur when the Pair button is pressed for specific time.
Pair button
Action
Status
Power LED Light Behavior
less than 3
seconds
The adaptor joins a network.
It shares the same network
name as other adaptors on
the Powerline network.
The Power LED turns on if
your adaptor is connected to
another Powerline adaptor or
a Powerline network.
more than 10
seconds
The adaptor leaves any
network it is associated with
and its network name
assumes a random value.
The Power LED turns off
when it disconnects from the
Powerline network.
Reset
To reset the Powerline AV device,
1. Please make sure
unplug (remove) the Ethernet cable
first, and then press the Reset button.
2. Press and hold the Reset button for 2 seconds. Release the Reset button when the Power LED begins to
blink. The default settings have been restored. Be careful,don’t power off when the device is in reset process
.
Ethernet Powerline Adaptor
27
Summary of Contents for PA200AV
Page 15: ...Ethernet Powerline Adaptor 11 ...
