background image

RAPID TOASTER VCT-200

1

P/N 1010710 Rev. N 02/13 

McDonald’s

RAPID TOASTER  

MODEL VCT-200 

Manufacturing Numbers 9200500/502/504/512

POW

ER

TEMP

DOW

N

TEMP
UP

TEMP

SCALE

˚C

˚F

CA

UT

ION

Place this manual in the Toaster section  

of your 

Equipment Manual. 

Manufactured exclusively for 

McDONALD’S®

 

BY

 

A.J. ANTUNES & CO. 

180 KEHOE BLVD. 

CAROL STREAM, ILLINOIS 60188, U.S.A. 

PHONE: 1-630-784-1000 

TOLL FREE: 1-877-392-7854 

FAX: 1-630-784-1650 

www.ajantunes.com

®

US

C

TABLE OF CONTENTS

Owner Information .....................................................2

General ......................................................................2

Warranty Information .................................................2

Service/Technical Assistance ....................................2

Specifications .............................................................3

Model Designation .....................................................3

Supplied Votages: ......................................................3

Electrical Cord & Plug Configurations .......................3

Toasting Time Change ...............................................3

Dimensions ................................................................4

Weights ......................................................................4

Important Safety Information ....................................5

Installation ...................................................................6

Unpacking ..................................................................6

Assembling the Unit ..................................................6

Location .....................................................................6

Operating Instructions ...............................................7

Toaster Operation ......................................................7

Fault Codes .............................................................10

Maintenance ..............................................................11

Daily cleaning ..........................................................11

Monthly: Bun Temperature Test ...............................12

Every Month: Replace Release Sheet Every Three 

Months: Replace Groovy Belt Wraps, Clean and 

Measure Conveyor Belts/Chains, Check Roller 

Tensioners and Check Temperature of Bun Landing 

Area. ........................................................................12

Measure the Conveyor Chains for Stretch  .............13

Replacing Groovy Belt Wraps  ................................14

Maintenance (continued) .........................................15

Adjusting, Measuring and/or Replacing Roller 

Tensioner Assemblies ..............................................15

Troubleshooting .......................................................16

Replacement Parts  ..................................................20

Wiring Diagrams .......................................................25

NOTES .......................................................................27

This manual is for the exclusive use of licensees and employees of McDonald’s Systems, Inc..  

© McDonald’s Corporation  All Rights Reserved

LIMITED WARRANTY

The Antunes Food Service Equipment Division of A.J. Antunes & Co. provides the following limited warranty to the original purchaser of all McDonald’s Equipment. 

All components are warranted against Manufacturer’s defects in the material and workmanship for a period of two (2) years from date of original installation not to 

exceed 30 months from the date of shipment from our factory. 

 

If any part becomes defective during the period of this Warranty, Antunes Food Service will pay negotiated straight time labor costs to an Authorized Service Agent to 

replace the part, plus travel expenses up to 100 miles/160 km, 2 hours round trip. 

Antunes Food Service reserves the right to make changes in design or add improvements on any products.  The right is always reserved to modify Equipment 

because of factors beyond our control and government regulation.  Changes to Equipment do not constitute a warranty charge. 

This warranty is exclusive and is in lieu of all other warranties, expressed or implied, including any implied warranty of merchantability or fitness for a particular pur-

pose, each of which is expressly disclaimed.  The remedies described above are exclusive, and in no event shall A.J. Antunes & Co. or any of its Divisions be liable 

for special consequential or incidental damages for the breach or delay in the performance of this warranty.

WARRANTY EXCLUSIONS

•  The cost of Installation.

•  Equipment that has been damaged due to shipment.  Purchaser should 

make damage claim directly upon carrier.

•  Alteration, misuse, abuse.

•  Improper storage or handling.

•  Improper maintenance.

•  Failure to follow proper Installation instructions, including electrical 

 

connection.

•  Improper or unauthorized repairs.

•  Scheduled Maintenance procedures as outlined in your MRC Card.

•  This Warranty does not cover Consumable items.

•  Water pressure problems or contamination problems such as foreign material 

in water lines or inside solenoid valves due to an incoming water source.

•  Overtime or Holiday charges.

•  Mileage over 100 miles/160 km round-trip, or travel time over two (2) hours.

•  Freight, foreign, excise, municipal or other sales or use taxes.

•  Consequential damages such as loss of profit, loss of time, the cost of 

 

repairing or replacing other property which is damaged, or any other  

incidental damage of any kind.

A.J. Antunes & Co.

Summary of Contents for VCT-200 Series





























Reviews: