11
Vertical contact toaster
P/N 1011097 Rev. A 03/12
A.J. Antunes & Co.
maIntenance
warnInG
turn the power off, unplug the power cord, and
allow the unit to cool down 30 minutes before per-
forming any service or maintenance.
caUtIOn
to prevent damage to the unit, do nOt use abra-
sive cleaners on the release sheet or belt wrap.
caUtIOn
Do nOt submerse the butter wheel heated base
in water. Do not wash this item with a water jet.
Do not spray cleansers directly on this item.
Daily
Tools Required:
• Heat-Resistant Gloves
• Clean Towels
• Multipurpose Detergent Solution
• Sanitizer Solution
1. Turn the power off to the unit and the Butter
Wheel Heated Base. Unplug the power cord and
clean the Release Sheet and Belt Wraps while
they are warm.
2. Put on heat-resistant gloves and remove the
Butter Wheel, Butter Pan, and Heat Shield
(Figure 1).
nOte: Do nOt submerse the butter wheel heated
base in water during cleaning. this item
should be wiped clean. Do not spray cleans-
ers directly on this item.
3. Wash the Butter Wheel, Butter Pan, and Heat
Shield in a sink and wipe them with a damp sani-
tized towel and allow them to air dry.
4. Remove the Release Sheet and place it on a
clean, flat dry surface.
5. Wipe one side of the Release Sheet with a
clean
towel dampened with Multipurpose Detergent
Solution immediately followed by a second clean
towel dampened with sanitizer and allow it to air
dry before continuing.
6. Repeat Step 5 on the other side of the Release
Sheet.
7. Open the front Conveyor Cover and firmly wipe
the Belt Wrap from left to right and top to bottom
with a clean towel dampened with Multipurpose
Detergent Solution immediately followed by a sec
-
ond clean towel dampened with sanitizer.
8. Close the front Conveyor Cover, open the rear
Conveyor Cover, and clean the Belt Wrap as
described in Step 7.
9. Close the rear Conveyor Cover. Reinstall the
Heat Shield, plug in the power cord, turn the unit
on, count 18 seconds, then turn the unit off and
unplug the unit.
10. Open the rear Conveyor Cover again and clean
the newly exposed section of the Belt Wrap in
the same manner as before. Close the Conveyor
Cover.
11. Open the front Conveyor Cover again and clean
the newly exposed section of the Belt Wrap in the
same manner as before.
12. Close the front Conveyor Cover and wipe down
the outside of the toaster with a clean, damp,
sanitized towel.
13. Install the Release Sheet by draping it over both
sides of the Platen with the crease centered on
the Platen.
nOte: to prolong the life of the release sheet,
rotate it from one side to the other on a daily basis.
14. Install the Bun Chute so the hooks are installed
over the lower rear yellow Support Rod.
15. Install the Heat Shield with the Release Sheet
retainer clips securely over the Release Sheet
and Platen.
16. Reinstall the Butter Wheel and Butter Pan, and
plug in the unit.
nOte: make sure the heat shield is activating the
conveyor safety Interlock switch. the conveyors
will not rotate unless the heat shield is in place
and the conveyor safety Interlock switch is
activated.
nOte: check the release sheet to make sure it is
not caught in the conveyor. additional release
sheets can be purchased through your authorized
service agency under p/n 7000625 (3-pack).
caUtIOn
failure to use release sheets may result in dam-
age to the unit and loss of warranty coverage.
