Vertical contact toaster
12
P/N 1011097 Rev. A 03/12
A.J. Antunes & Co.
maIntenance (continued)
INCORRECT
CORRECT
replacing the belt wraps (every 2–4 mo.)
nOte: the belt wraps should last between 2–4
months. additional belt wraps may be purchased
from your authorized service agency.
1. Turn the power off, unplug the power cord, and
allow the unit to cool before proceeding.
2. Unplug and remove the Butter Wheel Assembly,
and Heat Shield (Figure 1). Remove the cover
from the Bun Thickness Compression Knobs and
set them to 6 & 6.
3. Open both Conveyor Covers and pull the Belt
Wrap Pin out of the zipper on the conveyor Belt
Wrap (Figure 9).
4. Remove and discard the old Belt Wrap(s).
5. Clean both Conveyor Belt Chains just as
you would clean the Belt Wraps during Daily
Cleaning.
6. Install the new Belt Wraps around the Conveyor
Belt Chains inside the Upper and Lower Support
Rods with the zipper flap exposed and hanging
down (Figures 10 & 11).
7. Close the Conveyor Cover(s), set the Bun
Thickness Compression Knobs back to their
normal settings and reinstall the Heat Shield,
Butter Wheel, and Pan.
INCORRECT
CORRECT
figure 10. aligning belt teeth
caUtIOn
position the belt wrap inside the Upper and
lower support rods or damage to the unit may
occur.
caUtIOn
align the ends of the belt wrap properly
(figure 11) or the belt wrap may be damaged.
replacing the release sheet (every 3-5
weeks)
nOte: Depending on toaster usage and on how
well it is cleaned daily, the release sheet should
last between 21–35 days.
1. Remove and discard the Release Sheet.
2. Lay a new Release Sheet on a clean, dry surface
and fold it in half lengthwise and gently crease it
at the fold using only your fingers (Figure 8).
3. Install the Release Sheet just as you would after
Daily Cleaning.
Fold over so
ends meet.
Press Lightly with
finger to form crease.
figure 8. folding the release sheet
figure 9. removing belt wrap
Belt
Wrap
Belt Wrap Pin
Belt Wrap
Flap (Down)
