A & T Internationale Xserve, Service Source

Page: 113 / 165

Xserve (Late 2006) Take Apart — Logic Board
113
Packing the Used Logic Board: Xserve (Early 2008) Only
Important: This packing procedure applies only to Xserve (Early 2008) logic boards. When
packing the logic board, place the board in an antistatic bag and set it component-side up in the
return box so that the raised areas on the board fit correctly between the foam supports on the
box. Don’t bend or flex the logic board.
Holding the board at the long sides, place it in the antistatic bag. 1.
Note that foam supports are glued to the top of the box, as shown. 2.