8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
8
8
e
6 e
nterprise
r
eporter
Q
uick
s
tart
G
uide
8
a
ppendix
: san i
nstallation
Install the Unit
Link the ER Unit with the Fibre Channel Connected Device
This step is a continuation from the Storage Device Setup (for Attached Storage Units)
portion of Step 1A or 1B in the ER section. The procedures outlined in this step require
the use of the CAT-5E crossover cable and the Fibre Channel cable.
A. Plug the Fibre Channel cable into the slot on the upper middle section on the rear of
the ER unit (see Figure 1, Item A).
B. Plug one end of the CAT-5E crossover cable into the ER unit’s LAN 2 port—the port
to the right (see Figure 1, Item B) on the bottom left side of the chassis rear.
Figure 1: Back of the ER unit
C. Plug the other end of the Fibre Channel cable into the storage device’s HOST “1”
channel (see Figure 2, Item A).
Figure 2 - Back of the Nexsan SATABoy
D. Plug the other end of the CAT-5E crossover cable into the storage device’s NET “0”
port (see Figure 2, Item B).
E. Plug the storage device’s AC power cords into the rear sections of the unit (see Fig
-
ure 2, Item C).
