- 11 - - 11 -11
Rev D
11
Connecting the Power Cord
Insert the power cord receptacle end into the AC receptacle in the
back of the unit. Insert the power cord plug end into a standard AC
outlet. See the technical bulletin in this manual for power
requirements.
Turning the Unit
“ON” Using Rear Panel Switch
Activate the main power switch in the back of the unit next to the AC
receptacle. Your unit should then power on the lamp. After three to
six minutes the lamp should be fully warmed up and ready for use.
To avoid damage to the lamp DO NOT turn the
lamp off in the first three minutes while it is
warming up.
NOTE:
Avoid turning off and restarting the bulb during daily use
unless it will not be used for an extended time. Bulb life is
shortened by excessive restarts. For typical daily use it is
best to let it run.
NOTE:
This equipment has passed testing for EMI / RFI
radiation and susceptibility; however, if not installed and
used in accordance with the instructions, interference to
other devices in the near vicinity may occur. If this
equipment does cause harmful interference to other
devices, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures.
Reorient or relocate the receiving device.
Increase the separation between the equipment.
Connect the equipment into an outlet on a circuit
different from that to which the other device(s) are
connected.
Consult the manufacturer or field service technician for
help.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
