3. Next, to install the top fuselage piece
and vertical tail, apply epoxy to the
fuselage side edges and place the top
fuselage piece on top of your model.
Line up the top fuselage piece by placing
the front of the piece at the back edge of
the beginning of the canopy section.
Using small amounts of masking tape or
t-pins to hold the piece in place is
helpful and helps ensure proper
placement.
Tail Assembly continued on next page.
For the next step you will need the
triangular piece that bridges between the
main fuselage and the tail.
1. Apply epoxy and install making sure
to have good contact to the main
fuselage. It may be necessary to sand,
using a sanding block, the rear of the
fuselage to remove any excess depron to
ensure a tight fit.
Note: the piece does not extend to the
end of the tail section.
Nose Installation
For the nose installation, you will need
the small top fuselage piece, and the 3
pink foam nose cone pieces.
1. First, install the front fuselage piece,
making sure it is flush with the front
bulkhead. The shape of the kit requires
