15
+
Pairing handheld transmitters
with Radio motor Type RB:
The motor confirms
the programming
with 3 beeps and
down and up
OK
Beep from motor
+ down and up
Change direction of rotation
of radio motor:
The motor confirms
the programming
with 3 beeps and
down and up
OK
1 x Press button
P2 / Set Up
After switching on the power supply / Pressing P1 button the programming (pressing the
buttons) must be done within 10 sec. otherwise the motor returns to its original state.
1 x Press P1 button
or
1 x Press button
P2 / Set Up
1 x Press Up-button
or Down-button
+
+
Beep from motor
+ down and up
+
The motor confirms
the programming
with 3 beeps and
down and up
OK
+
+
+
Switch on power supply.
Only switch the affected motor
to voltage.
1 x Long beep from motor
+ down and up
+
1 x Long beep from motor
+ down and up
+
Press Up- Down-button
simultaneously for 2 sec.
If the up and down buttons triggers the wrong direction of travel, you can
change the direction of rotation of the radio motor with this programming.
Check whether the direction of rotation is correct before setting the end
points. A later change of the direction of rotation is only possible via the P1
button on the motor head!
PROGRAMMING RADIO TRANSMITTER
3T-MOTORS Radio tubular motors
| Programming radio transmitter
Important when teaching, changing or deleting transmitters:
Only one relevant motor may be switched to voltage!
Several radio motors or radio receivers can be programmed to form a group with the same transmission channel.
For multi-channel transmitters, channel by channel must be taught or transferred.
1 x Press button
P2 / Set Up
1 x Press button
P2 / Set Up
1 x Press Up-button
or Down-button
Beep from motor
+ down and up
Beep from motor
+ down and up
