3M Xtract 64256, User Manual

Page: 16 / 32

16
Fault Cause Remedy
Suction power drops
Filter dirty Clean
Filter bag full Change
Container full Empty
Motor protection fi lter blocked Clean
Nozzle, tube, or hose blocked Clean
Dust extractor does not start
Mains plug not in socket Plug plug into socket
No mains voltage Check fuse
Mains connection cable defective Replace
Cover not properly closed Close
Dust extractor in standby mode >A+< Set switch to >I+< (see “1 Display and Control Elements”)
The dust extractor does not start when the tool is
switched on in the>I+< mode
Electrical tool not plugged into socket on
the dust extractor
Plug mains plug into socket on the dust extractor
Dirt sticks in the pneumatic switch
mechanism
Rinse with alcohol (fi ll 6 drops through the male fi tting), tilt the dust
extractor for 1 minute slight to the back so that the control panel is parallel
to the fl oor. Run the tool with full speed and no load for 2-3 minutes.
Repeat if necessary.
Ensure clean air.
Input pressure < 6,2 bar/90psi Increase pressure to minimum 6.2 bar / 90 psi
Airfl ow demand < 120l/m /4,23scf Increase tool speed /airfl ow demand
PE emptying and disposal bag is sucked against
the fi lter
Incorrect position of rotary slide
Set rotary slide to position OPEN
▲
(see "5.4 Insert PE Emptying and Disposal Bag")
Dust extractor with dust classes M or H: with inserted
fi lter bag, dust is accumulating in the container
Incorrect position of rotary slide
Set rotary slide to position CLOSE
▲
(see "5.3 Insert Fleece Filter Bag (if available)")
Fill level indicator lights up
Filter blocked Clean or change
The suction hose is blocked Clean
Container is full Empty
Do not try anything else, contact customer services.
14 Technical Data
Voltage V 110-120
Frequency Hz 60
Rated power W 1400
Max. power* W 1800
Air fl ow** l/s (m³/h) 74
Negative pressure** hPa/MG 255
Air fl ow*** l/s (m³/h) 42
Negative pressure*** hPa/SE 235
Noise level dB(A) 69
Weight**** kg / lbs 15,5 (16,7****) / 34,17 (36,81****)
Dimensions (l x w x h) cm / ft 53 x 40 x 56 (92****) / 1,74 x 1,31 x 1,83 (3,01****)
* The maximum power in combination dust extractor and power tool
** at the fan
*** at the hose
**** incl. push handle
Mains connection cable on dust extractor for dust class M and H with plug socket: SJOW 3x16 AWG (100-120V).