18
When a confirmation for an action is
required, a button appears on the
right side of the message area. The
example to the right shows a case
where the edge sensors are covered
and a confirmation is required for the
SECURE action. The
Check-in
button is the default action so the
user can press the
Enter
key on the
keyboard to select it or touch the
Check-in
button on the screen.
4
Place the Item on the Deck.
Place the book or other item on the
deck in the correct position for
processing (
Figure 7
). See
Item
Placement
on page 21.
Figure 7: Correct Position For Processing
4
The system checks for a RFID tag or barcode.
If an RFID
tag is present, the workstation reads the tag.
If an RFID
tag is not present, the workstation goes into scan mode, which means the barcode scanner is
turned on after a short delay and the workstation reads the barcode.
5
If you are using Tattle-Tape strips for security, you will hear one of the following sounds:
A thump, indicating an item was secured or unsecured
A
beep
,
indicating that the
security strip was not secured or un-secured
(for example, for a video).
An
error or warning sound
,
indicating an error or warning
6
Remove the item and place the next item on the deck for processing.
After you hear the thump or beep sound, remove the item and place
the next item on the deck. If an error/warning sound occurs, follow the
on-screen instructions.
7
To continue processing items, repeat
Steps 4 - 6
above.
