Page 14 of 20
P/N 595305-01 Rev H 10/19
FIGURE 17
SLIDE JETTISON CLIP BACK ONTO BACKFRAME
WARNING
NEVER REMOVE THE SCBA FROM THE SELF-
RESCUE ACCESSORY UNLESS THERE IS A
COMPELLING REASON TO ASSUME THE RISK
OF INJURY FROM TERMINATING RESPIRATORY
PROTECTION IN ORDER TO FACILITATE ESCAPE.
TERMINATING USE OF THE RESPIRATOR IN A
HAZARDOUS ATMOSPHERE MAY RESULT IN
SERIOUS INJURY OR DEATH.
REINSTALLING THE JETTISON CLIPS
The Self Rescue Accessory can be reinstalled onto the SCBA by reattaching
the jettison clips as follows:
1. First, push the waist belt attachment loops from the rear (waist pad side) of
the backframe through the slots to the front (reducer side) of the backframe.
2. Then, slide the jettison clip onto side of waist belt making sure that:
a. the feet of the jettison clip are threaded through the waist belt loops
on the front side (reducer side) of the backframe; and
b. the tongue plate of the jettison clip is secured behind the rear (waist
pad side) of the backframe. The raised bar on the tongue plate will
snap into the open slot on the backframe when inserted properly.
For full video instructions demonstrating the installation of a Self Rescue
Accessory onto an AIR-PAK X3 Pro or AIR-PAK X3 SCBA backframe, please
visit
www.3MScott.com
.
FIGURE 16
REMOVE THE RESPIRATOR
3.
After the jettison clips are removed, perform a change of profile while maintaining
use of the respirator, OR terminate use of the respirator according to the OPERA-
TION AND MAINTENANCE instructions provided with the respirator. Remove the
regulator, loosen the shoulder straps, and remove the respirator.
DO NOT UNBUCKLE THE WAIST BELT.
See FIGURE 16
.
4. Proceed with use of the Fire Fighter Self-Rescue Accessory as described in these
instructions and in accordance with your hands-on training.
