Troubleshooting (continued)
Condition 1:
Applicator
will not heat
Ho
tM
elt
A
pp
lic
ato
rE
C
3
Sc
otc
h-W
eld
™
9. To remove the trigger (see Figure Q):
a. Use a small screwdriver to remove the E-ring from the pin at the
base of the trigger.
b. Remove the trigger pin.
c. Remove the trigger and spring.
10. If the temperature module is installed, remove it by unscrewing the
fastener and lifting out (see Figure O). Set aside until reinstalled.
11. Remove the six screws and hanger clip from the applicator handles.
Remove the left-handle (see Figure R).
Figure Q
Figure R
© 3M 2006
18
