Downloaded from Projector.com
19
3M
Multimedia Projector MP8020
1996
Retaining Screws: Use a standard screwdriver to
unscrew the lamp module retaining screws
(Figure 6-2).
Note
There are two lamp module screws that must
be loosened. These screws are
self-containing screws that cannot be
removed from the lamp module.
Screw
Screw
Lamp
Module
Figure 6-2. Lamp Module Retaining Screws
Remove Lamp Module: Grasp the lamp module
with one hand and the projector body opening with
the other hand (Figure 6-3). Apply upward pressure
to the projector body as you slide the lamp out.
Figure 6-3. Slide Lamp Out to Remove
Insert Lamp Module: Carefully insert the new lamp
module into the opening and slide it all the way back
into place (Figure 6-4). Check the lamp module to be
sure that it is fully inserted and flush against the back
wall.
Figure 6-4. Slide Lamp In to Insert
Tighten the lamp module retaining screws to secure the lamp module in place (Figure 6-2).
Insert the hinge tabs on the left side of the lamp access door, then close and tighten the retaining screw to
secure the door (Figure 6-1).
