Downloaded from Projector.com
16
3M
Multimedia Projector MP8020
1996
When the projector is displaying a video or computer image, press the H/V button to switch to the
MENU mode and the LED will begin flashing. Move the trackball left/right to adjust the image
horizontally or up/down to adjust the image vertically. When changes are complete, press the H/V
button to return to the NORMAL mode.
Note
The LED will stop flashing and return the remote control transmitter to the NORMAL mode
after five seconds of inactivity.
Sizes the picture to fit the screen. Press
to make the projected image wider or
to reduce the
image size.
Press
or
to focus the image.
Turn the audio (speaker) sound ON (mute bar turns green) or OFF (mute bar turns red).
This button displays a digital countdown clock in the upper left corner of the
projection screen. Minutes are displayed on the left and seconds on the right.
You can set the timer for the desired number of minutes to be counted down.
Seconds cannot be set – they are a display only field.
When the projector is in the Normal mode:
a. Press TIMER to display the clock. Figure 52.
b.
Press the RESET button to position the cursor in the left most minutes column.
c.
Press and hold RESET to put the remote in menu mode (LED will flash).
d.
Move the track ball up/down to change the digit.
e.
Move the track ball left/right to move to the next column.
f.
Press RESET to start the clock.
To reset the clock for a different amount of time, repeat steps b-f. To remove the clock display from
the projection screen, press TIMER.
Press to blank the screen (screen turns blue). Press again to return the normal display.
Press
to decrease or
to increase the speaker volume (NORMAL mode) or
to move
left/down or
to move right/up to adjust the setting of an on-screen menu line. See MENU
button.
The menu button is used to switch the projector and remote control between the NORMAL (Video
image and LED is Off) and MENU (On-screen Menu and LED is flashing) operating modes.
NORMAL Mode: (Video image being displayed, LED is Off) The normal operating mode is used to
display normal video images from your video or computer sources. Use the remote control buttons
to adjust the focus and volume levels of the projector and operate the mouse key functions (trackball,
drag, left/right) to control the video presentation.
MENU Mode: (On-screen Menu being displayed, LED is FLASHING) The MENU operating mode
is used to display on-screen Menus. These menus allow you to adjust the MP8020 projector settings
for best performance.
To make a projector setting change from the on-screen menu:
a. Press and release the MENU button to display the onscreen menu.
b. Press and hold the MENU button for two seconds to change the remote to the MENU
mode.
The LED on the remote will flash the entire time the remote is in the menu mode.
c. Move the trackball to make the desired changes on each Menu line.
d. Press the Menu button to return to the NORMAL mode.
e. Wait five seconds for the LED to stop flashing - remote automatically returns to Normal
mode.
H/V
←
→
↓
↑
00:00
Minutes : Seconds
Clock Display
Figure 5-2. Clock
