7
78-8140-3820-0-B
6.0 Cable Gauge Decal
Use the supplied cable gauge to determine the proper
cable clamp shells, washers and correct amount of
mastic needed to build a sealing collar.
6.1
Place cable gauge decal on cable as shown below. Be sure to place decal in-line with the cable.
Correct
Incorrect
6.2
Read between the arrows on the decal to determine
the amount of mastic, clamp shells and washer
needed to properly assemble the 3M
™
External Cable
Assembly Module (ECAM) Double Cable Entry Port
ECAM-20 mm-D. This information can be recorded
in the log below.
Note: If the arrows on the decal point at the line
between two different sizes, use what is listed in
the box below the line. Also note that no clamp
shells are required if the gauge indicates ‘NONE’
in the shell column.
Note: If two different-sized cables are used, repeat this
procedure for the second cable and record this
information in the Cable 2 section of the log.
LOG
Mastic Cut
Length
Cable Clamp
Shells
Washers
Cable 1
Cable 2
Note: To plug an unused port in the 27 mm Double ECAM assembly, use 14.0 inches (356 mm) of mastic
rolled into a cylinder.