3M 3M-Matic S-857, Instructions And Parts List

Page: 11 / 45

8
Installation and Set-Up
(Continued)
Air Regulator-Filter-Lubricator – The air control
unit is supplied with two mounting screws. Install the
unit on the main plate, left side, in the mounting
holes provided.
1. Refer to Figure 2-4 and locate the air control unit
(A) in a vertical position for proper operation.
Assemble and secure the two 8-32 x 1/2 lg.
screws and flat washers.
2. Refer to Figure 2-5 and push the air line (B) onto
the male elbow (C) on the right side of the air
lubricator as shown.
3. Unscrew the air lubricator bowl, Figure 2-5, and
fil with oil to 1/2 inch [12 mm] from top of bowl.
Do not overfill. Use U.S.P. heavy mineral oil or
SAE #5 or #10 non-detergent oil.
Screw bowl snugly back into place.
4. Connect main air supply line.
Note: The main air supply line and required
fittings are to be supplied by customer.
Turn On/Off valve on S-857 to "Off" position.
See Figure 2-4.
Connect main air supply line to main air supply
inlet on air regulator. See Figure 2-5.
Figure 2-4 – Installation – Air Control – Left Side View