3. Assemble Back
The four corner connectors are mirror images
of the front.
On each side are “mid panel corner
connectors”, which are basically simple L-
shapes for added strength.
The large 60mm hole is either for the included fan by itself, an air filter (purchased
separately)/fan combo, or it can be covered up by a plastic disk depending on how
much air flow you want.
Note that the fan, either by itself or paired with a
filter or vent is necessary to draw air over the power
supply.
This both heats up the air inside the
enclosure AND cools down the power supply,
which extends its life. Only use the circular disk
(not included) to cover up the hole if you have
moved the power supply outside of the enclosure,
or if you simply don’t care about power supply
longevity.
Confirm the direction of the fan’s air filter by
plugging it into a USB power supply before attaching to the filter and back of the
enclosure.
The fan should be oriented to pull air OUT of the enclosure.
Use the
long screws included in the fan packet to attach the fan. The length of the screws may
change depending on the depth of this particular
shipment of fans.
The U-shaped hole is for the cable grommet and
holder. This will allow you to remove the enclosure
without having to unplug the cables!
Copyright 2020 3DUPfitters LLC
9
