Now that the latches are mounted it is time to
connect the strike plates. Each plate comes with a
squishy adhesive covering the same size of the
plate. Carefully attach the adhesive side to the
acrylic at the location of each latch. Then, adjust
the width of the metal strike plate so that it is held
on by the pressure of the two sides of the plate.
The adhesive covering will keep the strike plate
from scratching the acrylic.
You can adjust the way the door swings by using the magnetic latch to hold the left
side of the door in place, and then placing the front on its side so the hinges are at the
top and the latch at the bottom. Loosen the screws and adjust the position of the
hinges so that there’s an even gap on all sides of the door. The door should open and
close freely.
When the front is finished it will look like the image to the right.
2. Attach Left Side
The left panel is distinguishable by its small hole
for a cable grommet, in addition to having “left
side” written on it. Insert the grommet as
pictured before attaching the front of the left-side
to the door frame. This is for connecting a USB
cable to the motherboard or to pass wires from
LEDs to a power strip.
Copyright 2020 3DUPfitters LLC
8
