View from
Outside
the Front
The front door is designed so that the latch is on the left.
Attach the corner connectors on the
inside
of the door
frame using the provided cap head 12mm screws. The
top of the connector should be flush with the top of the
acrylic. Adjust the screws snugly, but not tight as you’ll
adjust them later.
There is also a mid-panel corner connector to attach on the
right side. Use a 12mm M4 screws.
Locate the magnetic latches and use the
wood screws
to
attach them to the latch mounts. Hand tighten and make
sure they’re secure, but do not over tighten or they may
strip. The magnetic latch can be later adjusted front-to-
back to make sure the door is flush with the door frame.
Each latch mount is attached via three screws. Two M4
12mm cap heads are used to attach the latch mount to
the side, while a 30mm cap head secures the latch mount to the door frame.
Attach the hinges to the
outside
of the door and door frame using M4 12mm screws
and nuts. There will be some play in the hole size so that you can adjust the door to
swing freely.
Attach the door knob by first inserting the square M4 nut
into the slot. Use a 16mm cap head screw to attach the
door.
Copyright 2020 3DUPfitters LLC
7
