www.modellmarkt24.ch
23
33. Install the rudder servo in the designated location in the rudder tray.
Electronically center the servo and install the EF 4" pull-pull arm. Secure the cables
to the arm as show using 3mm bolts. As you'll notice in this picture we used the
SWB Pull-Pull Tensioning Kit which makes getting the proper tension on the cables
very easy and is a worthwhile investment. Please also note we are using the holes at
the 3.5" location for best geometry. The cables should be crossed in a X pattern
before exiting the rear of the fuselage through the tubes installed in the fuselage
sides.
34. There is a set of baffles that install behind the cowl openings to direct air over
the Xpwr 60. Do not omit installation of these baffles! They are a very important
part of the cooling equation for the Extra's power system! Glue them in place with
Goop or epoxy.
www.modellmarkt24.ch
