www.modellmarkt24.ch
15
Note: Before moving to the next step
–
it would be a good time to seal the hinge gaps
with a strip of Ultracote or Blenderm tape. Be sure to fully deflect the control
surface when sealing the gap to allow for full deflection once the gap is sealed.
Also, take a few minutes to go over the wings with a trim iron on a medium heat
setting to seal all the trim seams and remove any wrinkles in the covering. Use
caution and avoid excessive heat as this may cause the Ultracote to shrink too much
and lift at the seams.
Fuselage Assembly
18. Locate the Carbon Fiber main landing gear, 4 x 4mm bolts, lock nuts and
washers. Place the landing gear onto the landing gear plate on the bottom of the fuse
and align the 4 holes. Use a metric driver to attach the gear, securing with the 4
bolts, washers and nylon insert locking nuts inside the fuselage.
www.modellmarkt24.ch
