Kiwk-links and a small threaded pushrod with a hole in one end are provided for the ends of the cables.
This allows for small adjustment once all the cables are installed. Each wire is made up with the same
technique as the pull-pull rudder. Insert the small pushrods 4-5 turns into the kwik-links. Then install the
kwik-links to each hard point. Note: the top of the vertical stabilizer requires two (on each side), all others
receive one. Now bolt the had points to the stabilizers in the provided holes. There is a small slit in the
covering indicating the hole locations. Use the pictures for reference.
The bottom two hard points attached to the fuselage are installed using wood screws. Best to install the
wood screw, then remove and harden the wood with thin CA. Once dry, reinstall.
Now attach the cables using one crimp sleeve to each small pushrod. Do one cable at a time, taking up
as much slack as possible. Once all the cables are completed, the pushrods may be threaded into the