Installing the tail surfaces: Slide the carbon main wing spar tube into position. Without any glue,
temporarily install both the horizontal and vertical stabilizer as shown and check for alignment with each
other and the wing tube. Make any adjustments needed by sanding or shimming.
Do not remove any covering from the horizontal stabilizer. Instead, once you are satisfied with the
alignment of the horizontal stabilizer in all directions, apply thin CA glue as shown. It will wick into the
joint and permanently adhere the stab. We recommend this on all of our 30CC aircraft, gas or electric
powered. Clean up any excess CA on the covering with debonder.
Since there is bare wood exposed on the vertical stabilizer joint, you may use thin or thick CA or epoxy to
permanently install the vertical stab.